Table of Contents
Advertisement
3.0 - Confi guration & Assembly
Upon initial receipt of the #TFAT-14C system inspect the packaging for any evidence that the product may have been
damaged in shipment. While unpacking the product, inspect all of the components for damage. If damage to any of
the components is discovered, DO NOT USE THE PRODUCT! Alert the shipping carrier immediately of the damage
to the shipment.
MIDDLE ASSEMBLY
#500916-001
Figure 3b: #TFAT-14C
Diagram & Parts List
Verify that all parts are present before use.
The #TFAT-14C is normally shipped fully asssembled.
1. In some isolated cases, the lower & middle assembly may be separated for shipping purposes. If this is the case,
the lower and middle assembly must be joined prior to operation. Refer to the following steps to properly confi gure
the #TFAT-14C for usage.
2. To install the middle section to the lower section; fi rst, remove one of the handles from the handle shaft by turning
it counter clockwise.
3. Once one handle is removed from the shaft, pull on the other handle to extract the remaining handle & shaft from
the middle weldment.
4. Slide the middle weldment into the lower section while aligning the handle hole in the middle weldment with the
machined slot in the lower assembly.
5. Insert the shaft/handle assembly through the slot (lower) & the handle hole (middle) in order to join the two assem-
blies. Once the threaded handle shaft is through to the other side, re-attach the handle by threading it clockwise.
** Thread-locking compound is required on the handle threads in order to prevent the handle from working loose during
operation.
** Refer to parts list above if replacement parts are required. Replacement parts can be ordered from the T.A. Pelsue
Company at 800-525-8460.
Page 8
2
4
LOWER ASSEMBLY
#500912-001
#501003-001 - Product Manual: Model #TFAT-14C TELESCOPING FALL ARREST TOWER - Revision 00 - Date: 06-16-2008
3
MIDDLE ASSEMBLY
1
ITEM#
1.
500918-001
2.
500966-002
3.
500193-001
3
4.
500992-001
5.
500993-001
5
1
LOWER ASSEMBLY
ITEM#
1.
2.
3.
3
2
500916-001
PART#
DESCRIPTION
Weldment - Middle Section
T Handle Hitch Pin w/ Cotter
Bearing Collar
Handle Shaft
Handle (2X)
500912-001
PART#
DESCRIPTION
500913-001
Weldment - Lower Section
500551-001
Pin - Hitch with Ring Grip
500565-001
Screw Peg Assembly (2X)
Advertisement
Table of Contents
