Pelsue TFAT-14C Product Manual page 16

Telescopic fall arrest tower
Table of Contents

Advertisement

5.2 - Product Installation & Set-up (continued)
Composite
Tower
"T" Handle
Tower
Anchoring
Height
Adjustment
Handles(2X)
Page 16
c. Lower Position: If the #TFAT-14C is to be utilized in its lowest position,
remove the "T" Handle hitch pin at the upper end of the tower, insert the
Composite tower section into the #TFAT-14C** and reinsert the "T" handle
pin thereby securing the composite tube to the #TFAT-14C. The composite
tube may need to be rotated by hand in order to align the pin holes.
Middle & Upper Position: If the #TFAT-14C is to be utilized in either of
its middle or upper position, remove the "T" Handle hitch pin at the upper
end of the tower and insert the Composite tower section into the top the
#TFAT-14C**. Prior to securing, grasp the two protruding handles, one in
each hand, and raise the tower to its middle position. The middle section
must be rotated approximately 10 degrees in order to secure the handle
shaft into the inverted "J-shaped" slot. Re-Insert the "T" Handle pin thereby
securing the composite tube to the #TFAT-14C. The composite tube may
need to be rotated by hand in order to align the pin holes. Once the pin si
inserted, the tower can be extended and secured in its upper most position,
using the two handles, if maximum height is required.
d. A single lifeline may now be attached to any of the three tie-off rings located
at the top of the composite tower. Only a single lifeline may be attached
to the top of the tower at any one. Any attached lifeline must be equipped
with a 900 LB. MAF (Maximum Arrest Force) Fall Arrest Device.
**NOTE: It will likely be easier to attach the lifeline/SRL to the composite
towers anchorage point prior to inserting into to #TFAT-14C or elevating the
system to its desired position.
Pin
The 3-Person rating published on
the composite tower is not valid
when installed within the #TFAT-
14C system. The 3-Person rating
requires
#500019-001 Uni-Lite Base Assem-
bly.
Figure
#5.2d:
Composite
Component Tower Installation
#501003-001 - Product Manual: Model #TFAT-14C TELESCOPING FALL ARREST TOWER - Revision 00 - Date: 06-16-2008
! DANGER !
Installation
within
the

Advertisement

Table of Contents
loading

Related Products for Pelsue TFAT-14C

Table of Contents