Confi Guration & Assembly - Pelsue TFAT-11A Product Manual

3.0 - Confi guration & Assembly
Upon initial receipt of the #TFAT-11A system inspect the packaging for any evidence that the product may
have been damaged in shipment. While unpacking the product, inspect all of the components for damage.
If damage to any of the components is discovered, DO NOT USE THE PRODUCT! Alert the shipping carrier
immediately of the damage to the shipment.
UPPER TOWER
ASSEMBLY:
#500561-001
MID TOWER
ASSEMBLY:
#500562-001
LOWER TOWER
ASSEMBLY:
#500563-001
Figure 3.1: #TFAT-11A
Diagram & Parts List
Page 8
UPPER TOWER ASSEMBLY
ITEM# PART#
1. 121569-001
2. 118283-002
3. 100049-015
4. 100050-013
5. 107944-001
MID TOWER ASSEMBLY
ITEM# PART#
1. 500408-005
LOWER TOWER ASSEMBLY
ITEM# PART#
1. 500565-001
2. 500551-001
3. 500408-001
Verify that all parts are present before use.
The #TFAT-11A is normally shipped fully assembled.
In some isolated cases, the three main tower assemblies may be separated for
shipping purposes. If this is the case, all three assemblies must be joined prior
to operation. The three assemblies are joined by simply sling each smaller
tube inside of the next largest tube and then using the attached pins to secure
the sections in place.
** Refer to parts list above if replacement parts are required. Replacement parts
can be ordered from the T.A. Pelsue Company at 800-525-8460.
#500615-001 - Product Manual: Model #TFAT-11A TELESCOPIC FALL ARREST TOWER - Revision 01 - Date: 04-29-2010
500561-001
DESCRIPTION
Screw - socket head, SS
Washer - Flat, 5/16", SS
Screw - Cap, 1/2-13, plated
Washer - Flat, 1/2", plated
Nut - Stover, 1/2"-13, plated
1.
500562-001
DESCRIPTION
Pin & Lanyard - 1/2" x 3.8"
500563-001
DESCRIPTION
Screw Peg Assembly - 1"-8
Pin - Hitch, 3/4" x 8-1/2"
Pin & Lanyard - 1/2" x 4.5"
2.
1.
3.
5.
4.
3.
2.
1.