Table of Contents
Advertisement
Operation
Preflight Checklist
❏ Inspect the model, wiring, and electrical components.
❏ Activate Normal Flight Mode on the transmitter.
❏ Activate Throttle Hold on the transmitter. Lower the throttle to stop or
idle.
❏ Power ON the transmitter.
❏ Power ON the model, and wait for initialization to complete.
❏ Complete the tailrotor and cyclic tests.
❏ Connect the flight pack to the ESC (electric models).
❏ Verify that all connected remote receivers display a solid orange LED.
❏ Confirm that the transmitter roll, pitch, yaw and collective inputs cor-
respond to the helicopter controls.
❏ Confirm that the FC6250HX is compensating in the correct direction.
❏ Review all operational instructions before flying your model.
❏ Place the model on a level surface for take off.
Postflight Checklist
❏ Disconnect the flight battery (electric models)
❏ Power down the FC6250HX
❏ Always turn the transmitter off last
Telemetry Flight Log
The transmitter telemetry flightlog will provide the following information.
RX1 Fades
RX2 Fades
FC6250MHX Generated
Telemetry
Number of Remote
Receivers Connected
NOTICE: After a flight, if frame losses higher than 30 occur, evaluate the
remote receiver positioning and ensure the antennas have a clear signal
path to the transmission signal.
To help troubleshoot frame losses and holds, use the Range Test reduced
power function within your transmitter. Review your transmitter manual for
additional instructions.
EN
Total Fades
Total Holds
9
Advertisement
Table of Contents
