DFI AL051 User Manual page 26

ACPI Configuration
This section configures the system ACPI parameters.
InsydeH2O Setup Utility
Advanced
Wake On LAN <Disabled>
After G3 <Always Off>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
Wake On LAN
This field is used to enable or disable the LAN signal to wake up the system.
After G3
This field is to specify what state the system should be in when power is re-applied
after a power failure (G3, the mechanical-off, state).
Always On The system working state.
Always Off Off, except for trickle current to devices such as the power button.
Chapter 3 BIOS Setup Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Enable/Disable Wake On
LAN capability
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Note:
If Quiet Boot of Boot menu is set to enabled, BGRT Logo field will appear for
configuration. Refer to the Boot menu in this chapter for more information.
Advanced
Wake On LAN <Disabled>
After G3 <Always Off>
BGRT Logo <Enabled>
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
BGRT Logo
This field is used to enable or disable to support display logo with ACPI BGRT table.
26 26
InsydeH2O Setup Utility Rev. 5.0
Support display logo with
ACPI BGRT table.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi.com www.dfi.com