Maintenance And Care - MTD FH381V Manual

English
If required, top up with oil:
– Pour oil slowly into the refill
opening.
– Do not overfill!
Insert and tighten the dipstick.
Starting the engine
6MWO SJ YRMX ERH IRKMRI
HEQEKI
%P[E]W VIEH XLI YRMX STIVEXMRK
QERYEP *SPPS[ XLI WTIGMJMG
MRWXVYGXMSRW SJ XLI YRMX
QERYJEGXYVIV
r (S RSX EGXYEXI XLI WXEVXIV QSXSV
[LMPI XLI IRKMRI MW VYRRMRK
%W WSSR EW XLI IRKMRI WXEVXW
VIPIEWI XLI WXEVXIV QSXSV
r (S RSX EGXYEXI XLI WXEVXIV QSXSV
GSRXMRYSYWP] JSV PSRKIV XLER
 WIGSRHW
r -J XLI IRKMRI HSIW RSX WXEVX
MQQIHMEXIP] [EMX  WIGSRHW
ERH VITIEX
r 0IX XLI IRKMRI [EVQ YT FIJSVI
ETTP]MRK PSEH 8LMW [MPP IRWYVI XLEX
EPP IRKMRI TEVXW EVI PYFVMGEXIH
Turn on the petrol tap (optional)
(Fig. 3).
Insert the ignition key and turn to
the "ON"/"I" position
Units with combined throttle/
choke
If the engine is cold: Set the
throttle (A) to "Choke" position
(Fig. 5).
If the engine is warm: Set the
throttle to a position between
"Fast" and "Slow"
Units with separate choke
Do not actuate the choke if the
engine is very warm or if the engine
does not start immediately. The
engine would be flooded and would
be very difficult to start!
8
If the engine is cold: Pull the choke
(Fig. 6/example illustration).
Set throttle to "Fast" position
(Fig. 7/Example illustration)
Turn the ignition key to the "Start"
position
5 seconds (Fig. 4).
Release the key as soon as the
engine starts.
If the engine does not start
immediately, wait 10 seconds and
then repeat.
When the engine has started,
leave the engine to warm up for
3–5 minutes before starting work.
To do this, move the throttle to
a position between "Fast"
"Slow"
Separate choke: Slowly push
back the choke.
Stopping the engine
!
6MWO SJ MRNYV] ERH HEQEKI XS
TVSTIVX]
%P[E]W VIQSZI XLI MKRMXMSR OI] MJ XLI
YRMX YRMRXIRXMSREPP] W[MXGLIW SJJ
6MWO SJ WIVMSYW IRKMRI
HEQEKI
(Fig. 4).
3RP] MR ER IQIVKIRG] W[MXGL SJJ XLI
IRKMRI [MXLSYX VIHYGMRK XLI WTIIH
Planned stop
Reduce the engine speed.
To do this, move the throttle to the
"Slow" position
After approx. 20 seconds turn the
ignition key to the "OFF"/"0"
.
position
The engine stops.
Turn off the petrol tap (optional).
Emergency stop
Turn the ignition key to the "OFF"/
"0" position
The engine stops immediately.
Turn off the petrol tap (optional).
for a maximum
and
.
.
.
.
Operating manual for FH381V/FH430V
Settings
8LI TS[IV ERH GSRWYQTXMSR
SJ XLI IRKMRI LEW FII WIX STXMQEPP]
F] XLI QERYJEGXYVIV 8LIWI WIXXMRKW
QE] FI GLERKIH F] XLI
QERYJEGXYVIV SV ER EYXLSVMWIH
HIEPIV SRP]
Maintenance
and care
!
6MWO SJ MRNYV] HYI XS IRKMRI
YRMRXIRXMSREP WXEVXMRK
&IJSVI WXEVXMRK ER] [SVO HMWGSRRIGX
XLI GEFPI JVSQ XLI RIKEXMZI FEXXIV]
XIVQMREP ERH VIQSZI XLI WTEVO TPYK
XIVQMREP JVSQ XLI WTEVO TPYK
Maintenance schedule
Before using the unit:
– Check the oil level; if required,
top up.
– Check for loose or lost parts.
– Check for leaking fuel or oil.
– Check the air inlet; if required,
clean.
After the first 5 hours:
– Change the engine oil.
Every 25 operating hours:*
– Clean the air filter (foam element).
Every 50 operating hours:*
– Clean the air filter (paper element).
Every 100 operating hours:*
– Change the engine oil.
– Clean the spark plug and check
the gap.
– Check screw fittings; if required,
tighten.
– Clean the air inlet thoroughly.
– Remove dust and dirt from
cylinder and cylinder head.