Spark Plug; Long-Term Storage - Pramac P Series Operator's Manual

Inverter
Hide thumbs Also See for P Series:
Table of Contents

Advertisement

8 Maintenance
8.6

Spark plug

See image below
Clean or replace the spark plug as needed. See engine manual.
WARNING
The exhaust will become very hot during operation and also remains hot for a while
after the engine is switched off. Never touch a hot exhaust.
Comment: See the technical data for the recommended spark plug and spark plug
air gap.
1.
Remove and check the spark plug.
2.
Replace the spark plug if the isolator is cracked or split.
3.
Clean spark plug electrodes with a wire brush.
4.
Adjust the spark plug air gap (a).
5.
Screw in and tighten the spark plug.
NOTE: A loose spark plug can become very hot and lead to engine damage.
8.7
Long Term Storage
Long term storage of your machine will require some preventive procedures to
guard against deterioration.
Drain the fuel
1.
Turn the Engine switch to "O".
2.
Remove the fuel tank cap. Extract the fuel tank into an approved gasoline
container using a commercially available hand siphon. Then, install the fuel
tank cap.
WARNING
GASOLINE IS FLAMMABLE. DO NOT perform this maintenance while smoking
or near an open flame.
WARNING
Immediately wipe off spilled fuel with a clean, dry, soft cloth, since fuel may
deteriorate painted surfaces or plastic parts.
3.
Turn the Engine switch to "I".
38

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

P3000iP3500i/oP3500i

Table of Contents