Features Setup Page - IBM M950HLU Manual

Features Setup Page

This page sets up some parameters for those peripheral devices
connected to the system.
AMIBIOS SETUP – FEATURES SETUP
(C) 2000 American Megatrends, Inc. All Rights Reserved
OnBoard FDC
OnBoard Serial PortA
OnBoard IR Port
OnBoard Parallel Port
Parallel Port Mode
Parallel Port IRQ
Parallel Port DMA
OnBoard IDE
Audio Device
Modem Device
Ethernet Device
USB Controller
USB Device Legacy Support
ThumbDrive Support for DOS
Use this item to enable or disable the
OnBoard FDC
onboard floppy disk drive interface.
Use this item to enable or disable the
OnBoard
onboard COM1/2 serial port, and to assign
Serial PortA
a port address.
Use this item to enable or disable the
OnBoard IR
onboard infrared port, and to assign a port
Port
address.
Use this item to set the parallel port mode.
Parallel Port
You can select SPP (Standard Parallel Port),
Mode
ECP (Extended Capabilities Port), EPP
(Enhanced Parallel Port), or ECP + EPP.
Use this item to assign IRQ to the parallel
Parallel Port
port.
IRQ
Use this item to assign a DMA channel to
Parallel Port
the parallel port.
DMA
Use this item to enable or disable the
OnBoard IDE
onboard IDE channel.
This item enables or disables the AC'97
Audio Device
audio chip.
Enabled
3F8h/COM1
Disabled
378h
SPP
7
N/A
Both
ESC : Quit
Enabled
Item
Auto
F1 : Help
Enabled
F5 : Old Values (Shift)F2 : Color
Enabled
F6 : Load BIOS Defaults
Disabled
Disabled
F7 : Load Setup Defaults
27
↑↓←→ : Select
PU/PD/+/- : Modify