Table of Contents
Advertisement
Enable this item if you are using an O/S that
Plug and Play
supports Plug and Play such as Windows 95
Aware O/S
or 98.
This item indicates if the primary graphics
Primary
adapter uses the PCI or the AGP bus. The
Graphics
default AGP setting still lets the onboard
Adapter
display work and allows the use of a second
display card installed in an AGP slot.
If this item is enabled, an IRQ will be
Allocate IRQ
assigned to the PCI VGA graphics system.
to PCI VGA
You set this value to No to free up an IRQ.
This item enables or disables the DMA
PCI IDE
under DOS mode. We recommend you to
BusMaster
leave this item at the default value.
Load Optimal Settings
If you select this item and press Enter a dialog box appears. If you
press Y, and then Enter, the Setup Utility loads a set of fail-safe
default values. These default values are not very demanding and
they should allow your system to function with most kinds of
hardware and memory chips.
Note: It is highly recommended that users enter this option to
load optimal values for accessing the best performance.
Load Best Performance Settings
If you select this item and press Enter a dialog box appears. If you
press Y, and then Enter, the Setup Utility loads a set of best-
performance default values. These default values are quite
demanding and your system might not function properly if you are
using slower memory chips or other low-performance components.
26
Advertisement
Table of Contents
