IBM M950HLU Manual page 27

This item determines the operation of
DRAM CAS#
SDRAM memory CAS (column address
Latency
strobe). It is recommended that you leave
this item at the default value. The 2T
setting requires faster memory that
specifically supports this mode.
Enable this item to increase SDRAM
DRAM Bank
memory speed. When enabled, separate
Interleave
memory banks are set for odd and even
addresses and the next byte of memory
can be accessed while the current byte is
being refreshed.
Use this item to signal driving current on
AGP Comp.
AGP cards to auto or manual. Some
Driving
AGP cards need stronger than normal
driving current in order to operate. We
recommend that you set this item to the
default.
When AGP Driving is set to Manual, use
Manual AGP
this item to set the AGP current driving
Comp. Driving
value.
This item defines an AGP for the
AGP Aperture
graphics. Leave this item at the default
Size
value 64MB.
When this item is enabled, BIOS will
Auto detect
disable the clock signal of free
DIMM/PCI
DIMM/PCI slots.
Clock
Use this item to set the system bus
CLK GEN
spread spectrum for the installed
Spread Spectrum
processor.
If your P4 CPU is not HT CPU, this item
Hyper Threading
will be hidden. If your P4 CPU is HT
Function
CPU, BIOS will show this item. You can
set "Disabled" or "Enabled" to control
HT CPU support in O.S. Set "Enabled"
to test HT CPU function.
23