Table of Contents
Advertisement
Removing the rear clamp
4. Remove the motor support bracket.
Removing the motor support bracket
5. With the motor support bracket removed, gently pull back
on the motor. You may have to move it from side to side, but
it should start to move back. Pull it completely away from the
mounting studs on the tub and set down gently to work on it.
6. Remove the gasket from the tub.
7. Use a screwdriver to remove the wiring cover from the
motor wiring box. Take note of how the motor is wired up
because you will have to wire it up the exact same way when
you install the new motor.
8. Remove the conduit fitting from the motor wiring box.
9. Pull the conduit away from the motor and set old motor to
the side. Dispose of the old motor in accordance with warran-
ty or national/state/local guidelines, whichever may apply.
SECTION 5: SERVICE PROCEDURES
REPLACING CONVEYOR MOTOR
AJ-54C Series Technical Manual 7610-002-30-91
Issued: 03-22-2006 Revised: N/A
62
Removing the pump gasket
10. Remove the wiring cover on the new motor assembly and
pull the wires free. Install the conduit fitting.
11. Run the conduit to the motor, pulling the machine wires
through and into the motor wiring box.
12. Rewire the motor exactly the same way the old one was
wired and/or refer to the motor schematic to determine how
the motor should be wired for the incoming power. If you
require help on this, do not hesitate to contact Jackson
Technical Service. Ensure that all wiring is done in accor-
dance with national, state and local codes as applicable.
Remounting the wash motor assembly
13. Place the new motor gasket on the tub over the mounting
studs.
14. Carefully lift the motor assembly and slide it onto the
mounting studs.
15. Re-install the mounting hardware and tighten down.
Advertisement
Table of Contents
