Table of Contents
Advertisement
Removing the rear clamp
5. Remove the motor support bracket.
Removing the motor support bracket
6. With the motor support bracket removed, gently pull back
on the motor. You may have to move it from side to side, but it
should start to move back. Pull it completely away from the
mounting studs on the tub and set down gently to work on it.
7. Remove the gasket from the tub. If you are going to replace
it with a new one, do so at this time. Otherwise, carefully
examine the gasket for tears and other damage. If it is accept-
able, set to the side. If you are not going to replace the seal,
go to step 16.
Removing the pump gasket
SECTION 5: SERVICE PROCEDURES
REPLACING THE PUMP GASKET & SEAL (CONTINUED)
AJ-54C Series Technical Manual 7610-002-30-91
Issued: 03-22-2006 Revised: N/A
8. Using a large screwdriver (flathead preferred, but a phillip-
shead will work just as well) and the 7/16" socket, loosen and
then remove the bolt holding the impeller to motor shaft. Refer
to the picture below.
Removing the bolt that holds the impeller to the shaft
9. With the bolt and washer removed, grasp the sides of the
impeller and pull up gently. The impeller should slide off of the
shaft. Remove the woodruff key as well and set to the side.
Removing the impeller
Removing the woodruff key
43
Advertisement
Table of Contents
