Table of Contents
Advertisement
Setting the oven
Here you can find out how to set the oven.
This is how you adjust the lower gas burner in
the oven
When the lower gas burner is lit, you can bake on a baking
sheet with the oven door closed.
Example in the picture: Heat to 170 °C
Open the top cover. The top cover must remain open for as
1.
long as the oven is in operation.
Open the main gas supply to the appliance. Connect the plug
2.
in the socket. Open the oven door.
Push in the switch for the lower gas burner and turn it to
3.
170 °C.
While holding the switch for the lower gas burner depressed,
4.
press the ignition button
The gas escaping from the oven's lower gas burner is ignited
5.
using the ignition button. To activate the safety pilot, press
and hold the lower gas burner on the oven for 10 seconds.
The safety pilot is activated. If the gas flame goes out, the gas
supply is automatically interrupted by the safety pilot.
Look through the inspection port to make sure that the flame
6.
is lit. If it is not, repeat the process from step 3.
Close the oven door slowly.
7.
Preheat the empty oven for approximately 15 minutes before
8.
baking.
When the dish has finished cooking, turn off the switch for the
9.
lower gas burner.
You can change the temperature at any time.
:
Caution!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
Procedure for setting the gas grill
Open the top cover. The top cover must remain open for as
1.
long as the oven is in operation.
Turn on the main gas supply to the appliance. Connect the
2.
plug to the socket.
16
8
.
Insert the protecting plate into the groove under the control
3.
panel.
The protecting plate is inserted with the longer edge facing
forwards and the curvature facing downwards.
Fasten the protecting plate in the groove under the control
panel using the retainers.
Make sure that the protecting plate is latched into the
retainers. Once the protecting plate cannot be removed, it is
correctly latched in place. You can now safely use the
protecting plate. If it can be removed, insert it into the groove
at a slightly higher angle and make sure that it latches into
the retainers.
Close the oven door so that it is in contact with the protecting
4.
plate.
Press the function selector and turn it clockwise to the grill
5.
setting
.
#
Keep the function selector pressed in and simultaneously
6.
press the ignition button
The gas leaving the gas grill is ignited using the ignition
7.
button. To ensure that the ignition safety system responds,
press and hold the function selector for 10 seconds.
The ignition safety system is activated. If the gas flame goes
out, the gas supply is automatically interrupted by the ignition
safety system.
Check whether the flame is lit. If the flame is not lit, repeat the
8.
process from step 5.
Once the meal is cooked, switch off the function selector.
9.
Once the oven has cooled down, remove the protecting
plate.
:
Caution!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.
.
8
Advertisement
Table of Contents
