Kodak EOS-DCS 1 User Manual page 251

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message
"Can not save these
images because the
destination folder or disk
is locked, or you do not
have 'write privileges' to
the folder."
"Can not 'Take Picture.'
EOS-1 N is in ONE SHOT
focus mode and can not
focus."
"Can not 'Take Picture.'
The camera back may
©
be busy.
The camera can not be
©
electrically tripped."
"Can not 'Take Picture.'
The N90s may be in S
©
focus mode and can
not focus.
The N90s may be in P
©
exposure mode and its
lens is not stopped
down or could not
focus."
"Color balance can not be
applied to monochrome
images."
Possible Cause
A problem occurred
while writing the file. For
example, the disk is
locked, or write
protected, or there is
another problem with
the hard disk.
This is normal operation
of the camera.
This message only
applies to the DCS 465.
This is normal operation
of the camera.
An monochrome image
is selected for color
balancing; color
balancing can not be
applied to monochrome
images.
Reference — Kodak Driver Software
©
Suggested Solution
Unlock the disk, change write
protection, or write the file to
another disk if available.
Choose another focus mode or try
to focus on another part of the
subject that allows the camera to
focus.
If you are working with an
electrically tripped camera, wait for
the camera to complete the current
operation and then try again.
Or if the camera can not be
electrically tripped, you can not
use the Take Picture button with
this camera. Instead you must trip
the camera manually.
If you are in S focus mode, choose
another focus mode or shoot from
another position that allows the
camera to focus.
If you are in one of the
programmed exposure modes, be
certain that you set the lens to its
smallest aperture and that the
camera can focus.
When click balancing, work only
with color images.
G
8-63