First Connection; Initial Preheating; How To Set: Water Hardness - AEG BSE782380B User Manual

Remove all accessories and
removable shelf supports from
the oven.

5.2 First connection

The display shows welcome message after the first connection.
You have to set: Language, Display brightness, Key tones, Buzzer volume, Water hardness,
Time of day.

5.3 Initial preheating

Preheat the empty oven before the first use.
Step 1 Remove all accessories and removable shelf supports from the oven.
Step 2
Set the maximum temperature for the function:
Let the oven operate for 1 h.
Step 3
Set the maximum temperature for the function:
Let the oven operate for 15 min.
The oven can emit an odour and smoke during preheating. Make sure that the room is ventila‐
ted.

5.4 How to set: Water hardness

When you connect the oven to the mains you have to set the water hardness level.
Use the test paper supplied with the steam set.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later than 1
min after test.
Clean the oven and the ac‐
cessories with a soft cloth,
warm water and a mild deter‐
Step 2
Shake the test paper
to remove the excess
of water.
BEFORE FIRST USE
gent.
.
.
Step 3
After 1 min, check
water hardness with
the table below.
Place the accessories and the
removable shelf supports in
the oven.
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.
13/48