Graco Edge II 17R236 Operation, Parts page 23

3. Move trigger slide from SPRAY position
(A) to NEEDLE REMOVAL position (B).
SPRAY
Position
A
4. Remove needle from front of gun.
NOTICE
Do not use a pliers to remove needle.
Damage to the needle tip will cause leaking
at the fluid nozzle.
3A5097D
NEEDLE
REMOVAL
Position
B
5. Wipe or flush fluid from nozzle and
needle. If necessary, clean retaining
ring, air cap, air cap guide, and spring.
Do not use metal tools to clean the fluid
nozzle or air cap holes as this may scratch
them, causing fluid leaks and a distorted
spray pattern.
6. Using a squeeze bottle, flush cleaning
fluid through the gun. Hold the gun
upside down, pull the trigger, and
dispense cleaning fluid into the cup
connection.
ti30851a
7. Re-install needle and move trigger slide
from NEEDLE REMOVAL position (B) to
SPRAY position (A).
8. Trigger the gun and install spring, air cap
guide, and fluid nozzle. Install air cap
and retaining ring.
ti30852a
Cleanup
NOTICE
ti30853a
23