How To Wire Your Ceiling Fan - Fanimation PC/DC FPD7619 Series Manual

Hide thumbs

Table of Contents

Available languages

How to Hang Your Ceiling Fan (Continued)

WARNING

To avoid possible shock, do not pinch wires between

the hanger ball assembly and the hanger bracket.

WARNING

Failure to seat tab in groove could cause damage to

electrical wires and possible shock or fire hazard.

Carefully lift the fan and seat the downrod/hanger

ball assembly onto the hanger bracket that was just

attached to the outlet box. Be sure the groove in the

ball is lined up with tab on the hanger bracket.

(Figure 4)

Attach the safety cable to ceiling support cable.

Slide cable clamp and washer onto safety cable

(from fan). Place the end of cable through the loop of

ceiling support cable. Pull as much cable through loop

as possible. Feed end of cable into clamp hole and

firmly tighten screw. (Figure 4)

WARNING

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before wiring.

(Figure 1)

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advice, as it must be

grounded for safe operation.

NOTE: If you feel that you do not have enough

electrical wiring knowledge or experience, have your

fan installed by a licensed electrician.

Option A- with black and white supply wires only

Connect the green grounding lead from the

downrod and the green grounding lead from the

hanger bracket to the supply grounding conductor

(this may be a bare wire or wire with green colored

insulation). Securely connect wires with wire connector.

Securely connect the white fan motor wire to the white

supply (neutral) wire using wire connector. Securely

connect the black fan motor wire to the black supply

wire using wire connector. (Figure 2A)