Table of Contents
Advertisement
Network
TCP/IP
The interface is shown as following.
IP Version: There are two options: IPv4 and IPv6. Right now, system supports
these two IP address format and you can access via them.
MAC address: The host in the LAN can get a unique MAC address. It is for
you to access in the LAN. It is read-only.
IP address: Here you can use up/down button (
) or input the
corresponding number to input IP address. Then you can set the
corresponding subnet mask the default gateway.
Default gateway: Here you can input the default gateway. Please note
system needs to check the validity of all IPv6 addresses. The IP address
and the default gateway shall be in the same IP section. That is to say, the
specified length of the subnet prefix shall have the same string.
DHCP: It is to auto search IP. When enable DHCP function, you can not
modify IP/Subnet mask /Gateway. These values are from DHCP function.
If you have not enabled DHCP function, IP/Subnet mask/Gateway display
as zero. You need to disable DHCP function to view current IP information.
Besides, when PPPoE is operating, you can not modify IP/Subnet mask /
Gateway.
70
Advertisement
Table of Contents
