Connecting With Wireless Lan - Panasonic PT-TMZ400 Operating Instructions Manual

Projector settings
1) Connect the projector to a computer using a LAN cable.
2) Turn on the power of the projector.
3) Select the [NETWORK] menu → [WIRED LAN] from the main menu and press the <ENTER> button.
4) Perform the detailed setting of [WIRED LAN].
f For details, Refer to "[WIRED LAN]" (x page 97).
Note
f To connect to an existing network, perform after consulting your network administrator.
f Wireless LAN and wired LAN cannot be used in the same segment.
r Factory default setting
f Following setting has been made as a factory default.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1] / [DNS2]
Operating the computer
1) Turn on the power of the computer.
2) Perform the network setting following the instruction of your network administrator.
f If the projector is in factory default setting, you can use it as it is if the network setting of the computer is as
follows.
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]

Connecting with wireless LAN

The wireless module (Model No.: AJ-WM50) of the optional accessories is required if you want to use the network
function through the wireless LAN.
Connection example
Preparation and confirmation of the projector
1) Turn on the projector.
2) Attach the wireless module (Model No.: AJ-WM50) of optional accessories firmly into the <USB
(VIEWER/WIRELESS/DC OUT)> terminal.
3) Press the <NETWORK/USB> button to switch to NETWORK input.
Chapter 5 Operation of Function - Network connection
[OFF]
192.168.10.100
255.255.255.0
192.168.10.1
(Blank)
192.168.10.101
255.255.255.0
192.168.10.1
IEEE802.11b/g/n
Wireless module of optional accessories
(Model No.: AJ-WM50)
ENGLISH - 111