Table of Contents
Advertisement
No display
.
Check that the batteries are correctly inserted into the handset and fully charged.
.
Check that the handset is switched on. Press
No dial tone
.
Check that the telephone line cord is properly connected.
.
Another handset may be using the line. Wait for the other handset to hang up.
icon flashing
.
Handset is out of range. Move closer to the base.
.
Check the mains power is connected and switched on.
.
Handset not registered to the base. To register a handset, see page 28.
Base or handset does not ring
.
Check that the ringer volume has not been set too low or Off, see page 21
and 24.
Keypad does not seem to work
.
Check that the keypad lock is not on, see page 16.
.
Try removing the batteries and putting them back again.
Incoming caller's number is not displayed even though you have Caller
Display
.
Caller has to allow their number to be sent. It has been withheld or is
unavailable.
Answering machine will not record new messages
.
Is the recording memory full? Play and delete messages, see pages 31-32.
.
Is the OGM set to Answer Only? Change the OGM to Answer & Record,
see page 34.
End call.
38
Advertisement
Table of Contents
