Table of Contents
Advertisement
f
Place the upper thread spool for the needle on the right
side onto the spool pin, and then secure it with the
spool cap.
The thread should unwind from the front at the bottom
of the spool.
1
2
Thread the upper thread in the same way that the
g
upper thread for the left side was threaded.
h
Without passing the thread through the needle bar
thread guide, manually thread the right needle.
Insert the thread through the eye of the needle from the
front to the back.
Attach zigzag foot "J".
i
• For details on changing the presser foot, refer to
"Replacing the presser foot" on page 24.
Note
• When using the twin needle, be sure to attach
zigzag foot "J". If bunched stitches occur, use
monogramming foot "N" or attach stabilizer
material.
j
Touch
to unlock all keys and buttons.
k
Touch
, set [Twin Needle] (page 1 of the settings
screen) to [ON] and touch
CAUTION
• When using the twin needle, be sure to select
the twin needle setting, otherwise the needle
may break and cause injury.
l
1 Spool cap
2 Spool
m
You can use the
Stitch patterns sewn so that they create a step effect are called
step stitch patterns.
Touch these keys to shift the stitch pattern to the left or right
by half width of the stitch pattern.
Example:
a
b
.
Select a stitch.
• Refer to "Stitch Chart" on page 39 for stitches that
use a twin needle. You can also sew with a twin
needle when you select a 7 mm satin stitch pattern.
In this case, use zigzag foot "J".
CAUTION
• When using the twin needle, be sure to select
an appropriate stitch, otherwise the needle
may break and cause injury.
Start sewing.
CAUTION
• Do not try turning the fabric while the twin
needle is down in the fabric, otherwise the
needle may break and cause injury or may
damage your machine.
Making step stitch patterns
keys to create a step effect.
Touch
.
Select a stitch.
Utility Stitches
3
65
Advertisement
Table of Contents
