Table of Contents
Advertisement
f
Change the needle position so that the needle does not
touch the presser foot.
For details, refer to "Setting the stitch width/stitch
length/"L/R Shift"" on page 32.
1 Needle drop point
Note
• After adjusting the needle position, slowly turn the
handwheel toward you (counterclockwise) and
check the needle does not touch the presser foot.
g
Securely tighten the positioning screw.
h
Topstitch around the zipper.
1
3
2
4
1 Stitching
2 Right side of fabric
3 Basting stitching
4 End of zipper opening
CAUTION
• When sewing, be sure that the needle does not
touch the zipper, otherwise the needle may
break and cause injury.
i
Remove the basting stitching.
1
■ Inserting a piping
a
Place the piping between two fabrics inside out, as
shown below.
1
2
3
b
Attach the adjustable zipper/piping foot. (page 54)
c
Sew along the piping.
d
After sewing, turn them over.
Appliqué, patchwork and quilt stitching
■ Appliqué stitching
a
Baste or glue the appliqué piece to the base fabric to
secure it.
IMPORTANT
• If glue is used to hold the appliqué in place on
the fabric, do not apply glue to areas that will
be sewn with the machine. If glue adheres to
the needle or bobbin case, the machine may
be damaged.
b
Attach the zigzag foot "J" or the open toe foot (sold
separately with some models) shown below.
Zigzag foot "J"
c
Select a stitch.
No.
1-33
Stitch
• For details, refer to "Stitch Chart" on page 39.
Utility Stitches
1 Fabric
2 Piping
3 Fabric
Open toe foot
1-34
2-03
2-04
55
3
Advertisement
Table of Contents
