Table of Contents
Advertisement
h
Press
(Thread cutter button) once.
Raise the presser foot, and then remove the fabric.
Note
• When using the thread cutter on the left side of the
machine or scissors to cut the threads, press
(Needle position button) to raise the needle, raise
the presser foot, and then pull out the fabric before
cutting the threads.
i
Raise the buttonhole lever to its original position.
j
Insert a pin along the inside of one bar tack at the end
of the buttonhole stitching to prevent the stitching
from being cut.
1
k
Use the seam ripper to cut towards the pin and open
the buttonhole.
1
For keyhole buttonholes, use the eyelet punch to make
a hole in the rounded end of the buttonhole, and then
use the seam ripper to cut open the buttonhole.
• When using the eyelet punch, place thick paper or
some other protective sheet under the fabric before
punching the hole in the fabric.
CAUTION
• When opening the buttonhole with the seam
ripper, do not place your hands in the cutting
direction, otherwise injuries may result if the
seam ripper slips.
1 Pin
1 Seam ripper
1 Eyelet punch
1
■ Sewing buttonholes on stretch fabrics
When sewing buttonholes on stretch fabrics, use a gimp
thread.
Hook the gimp thread onto the part of buttonhole foot
a
"A" shown in the illustration.
b
It fits into the grooves, and then loosely tie it.
c
Attach buttonhole foot "A".
d
Select a stitch.
No.
4-05
Stitch
• For details, refer to "Stitch Chart" on page 39.
e
Adjust the stitch width to the thickness of the gimp
thread.
f
Lower the presser foot lever and the buttonhole lever,
and then start sewing.
g
When sewing is finished, gently pull the gimp thread to
remove any slack.
h
Use a handsewing needle to pull the gimp thread to the
wrong side of the fabric, and then tie it.
Utility Stitches
4-06
51
3
Advertisement
Table of Contents
