Eaton CROUSE-HINDS MTL LS Serues Instruction Sheet

Instruction sheet
MTL surge protection
MTL LS Range
Operating Instructions for
LED Lighting Type 2 SPD
Installation
1) Turn off all power supplying this equipment.
2) Mount the SPD using the enclosure flanges to a flat surface.
3) Connect the wire leads as per the wiring diagrams below.
4) For optimal device performance, use shortest length of wire possible and avoid
sharp or unnecessary bends.
Product Characteristics
Model
LS10-347V-S
LS10N-347V-S2
LS10-480V-S
LS10N-480V-S2
LS12-347V-P
LS12N-347V-P2
LS12-480V-P
LS12N-480V-P2
1
Do not attempt to open or tamper with the SPD in any way as this will
compromise performance and will void the warranty.
Megger and hi-pot tests will damage this device. Disconnect all power
supplying the equipment and isolate the SPD unit before testing.
Prior to installation, confirm the SPD is rated for the correct voltage,
and frequency equivalent to the application.
Voltage
120-347, 5A
480, 5A
120-347 PARALLEL
480 PARALLEL
Eaton Electric Limited,
Great Marlings, Butterfield, Luton
Beds, LU2 8DL, UK.
Tel: + 44 (0)1582 723633 Fax: + 44 (0)1582 422283
E-mail: mtlenquiry@eaton.com
www.mtl-inst.com
© 2017 Eaton
All Rights Reserved
Publication No. INS 801-745 Rev B 060117
January 2017
January 2017
INS 801-745 Rev B
CAUTION
Conn Modes
SERIES L-N, L-G, N-G 50/60
SERIES L-G, L-L
L-N, L-G, N-G 50/60
L-G, L-L
Freq In Diagram
3 kA A
50/60 3 kA B
3 kA C
50/60 3 kA D