Advertisement
GreyT Turret (11" ID) - User Guide
(Rev 1)
Step 3
Slide the 1/4"-20 x 1-1/4"L Bolts through the holes marked in green below. Slide all
components on to the bolt as shown in the image below. Make sure there is one 0.03"
thick Steel Washer between the plate and each 1/4" ID x 3/4" OD Radial Bearing.
Repeat this step for the remaining seven bearing bolt holes.
While assembling the parts in this step, use a piece of tape to hold the head of the bolt in
place so that the bolt does not fall out. This will also help in future steps.
Warning: Failure to install the washers will greatly increase the friction in the system
and may result in the turret not being able to rotate.
Table of Contents
Page 8
wcproducts.com
Advertisement
