WCP GreyT Turret User Manual page 7

GreyT Turret (11" ID) - User Guide
(Rev 1)
Step 2
Press the 1/2" ThunderHex ID x 1-1/8" OD Flanged Bearing in to the assembly from Step
1. For this turret, the bearing must be pressed in from the bottom of the assembly.
Note: If you plan on using the turret with a compatible thin section 12�5" OD bearing
(SA120XPO), the Turret Base and Ring plates will have to be tapped together� This will
allow you to use #10-32 x 3/8"L Bolts (WCP-0252) to constrain the thin section bearing�
Table of Contents Page 7
wcproducts.com