Care And Cleaning; Warranty - Klipsch RC-62 Owner's Manual

Surround Channel Speakers (See Figures 3 and 4.)
• Place above seated ear height (5 to 7 feet above the floor) on
side or rear walls.
• Use the attached wall bracket to hook to an appropriately sized
screw head screwed into a wall stud or wall anchor with a
suitable weight bearing capacity. (See Figure 4.)
• See your Klipsch dealer for optional, adjustable wall mounts if
required. These mounts utilize the threaded bushings on the
rear of the cabinet.
Caution! Never use the attached wall bracket for
mounting the speaker to the ceiling!
CONNECTING
Caution! Turn your amplifier off before making
any connections.
• Your loudspeakers are equipped with positive (Red) and
negative (Black) connection terminals on the rear of the
cabinet. These correspond to the positive and negative
terminals on the appropriate channel (left, right, center, rear
etc.) of your amplifier.
Standard Connections (See Figure 5.)
• All speakers in your system must be connected in phase with
the positive speaker terminal connected to the positive amplifier
terminal. Repeat this for the negative speaker terminal and
amplifier terminals. Most speaker wire has distinguishing
markings on the insulation of one of the conductors to assist in
correct hookup.
• Use 16 gauge (AWG), two conductor, copper wire at a
minimum and larger gauge wire for longer runs. The connection
terminals on your loudspeaker will accommodate bare wire,
spade terminals or banana type plugs.
• Use either pair of positive and negative terminals keeping the
metal coupling straps in place.
Caution! With all connection types, take care that there is
no contact between the positive and negative terminals
at the speaker and amplifier. Damage to your equipment
may result!
Bi-wire Connections (See Figure 6.)
Some models are equipped with two pairs of connection
terminals for bi-wire hookup and enhanced performance.
• Remove the metal coupling straps.
Bass Management
When using your speakers in a home theater system, consult
the owner's manual of your surround electronics for proper
application of bass management settings.
• As a general rule, compact speakers (Bookshelf, Center
Channel and Surrounds) are set to the "Small," or bass-limited
setting.
• Floorstanding speakers are typically set to the "Large," or
full-range setting.
• Also refer to the electronics instructions for adjusting the
relative volume levels of the speakers so they are at the same
level when in the listening position.

CARE AND CLEANING

• Occasional dusting or wiping of the cabinet with a damp cloth
is all that is required. Never use abrasive or solvent type
cleaners or harsh detergents.
• A vacuum cleaner with a soft brush attachment may be used to
clean the grille fabric.
• Never spray polishes or cleaners on the drive units (woofers,
midranges or tweeters).

WARRANTY

USA and Canada Only
The Warranty below is valid only for sales to consumers in the
United States and Canada. KLIPSCH, L.L.C. ("KLIPSCH")
warranties this product to be free from defects in materials or
workmanship (subject to the terms set forth below) for a period
of five (5) years from the date of purchase. During the Warranty
period, Klipsch will repair or replace (at KLIPSCH's option) this
product or any defective parts (excluding electronics and
amplifiers). For products that have electronics or amplifiers, the
Warranty period on those parts is for a period of two (2) years
from the date of purchase.
To obtain Warranty service, please contact the KLIPSCH
authorized dealer from which you purchased this product. If your
dealer is not equipped to perform the repair of your KLIPSCH
product, it can be returned, freight paid, to KLIPSCH for repair.
Please call KLIPSCH at 1-800-KLIPSCH for instructions. You will
need to ship this product in either its original packaging or pack-
aging affording an equal degree of protection.
Proof of purchase in the form of a bill of sale or receipted invoice,
which is evidence that this product is within the Warranty period,
must be presented or indicated to obtain Warranty service.
This Warranty is invalid if (a) the factory-applied serial number
has been altered or removed from this product or (b) this product
was not purchased from a KLIPSCH authorized dealer. You may
call 1-800-KLIPSCH to confirm that you have an unaltered serial
number and/or you purchased from a KLIPSCH authorized dealer.
This Warranty is valid only for the original purchaser and will
automatically terminate prior to expiration if this product is sold or
otherwise transferred to another party.
This Warranty does not cover cosmetic damage or damage due
to misuse, abuse, negligence, acts of God, accident, commercial
use or modification of, or to any part of, the product. This
Warranty does not cover damage due to improper operation,
maintenance or installation, or attempted repair by anyone other
than KLIPSCH or a KLIPSCH dealer which is authorized to do
KLIPSCH warranty work. Any unauthorized repair will void this
Warranty. This Warranty does not cover product sold AS IS or
WITH ALL FAULTS.
REPAIRS OR REPLACEMENTS AS PROVIDED UNDER THIS
WARRANTY ARE THE EXCLUSIVE REMEDY OF THE CONSUMER.
KLIPSCH SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR