Allen + Roth ARSTDF26I Manual page 12

HEATER CLEARANCES
For convenience and efficiency, install the heater with these points in mind:
• Provide easy access for operation, inspection and service.
• Install the heater in the coldest part of the room.
If this heater is installed directly on carpeting, tile, or other combustible material, other than wood flooring,
the heater must be installed on a metal or wood panel that extends the heater's full width and depth.
CAUTION
Clearances to Combustibles:
Carefully follow the instructions below. This stove is designed to set on the floor using the support legs.
WARNING
Fig. 3— Clearances as Viewed from the Front of the Heater (Inches)
*Left / Right
12 in.
Top clearance is from the top of the heater to the ceiling, wood shelf, or other combustible material.
Bottom clearance is from the bottom of the heater to the surface of carpet, tile, or other combustible material.
*A second side wall must be at least 18 in. away from the other side of the heater. Always maintain a
minimum of 36 in. clearance from furniture and draperies.
*For the installation in residential garages, refer to the CAUTION statement above.
Installation (cont.)
If you install the heater in a home garage, a.) ensure the heater pilot and burner are at
least 18" above the floor and, b.) locate the heater where moving vehicles will not hit it.
Maintain the minimum clearances shown in (see Fig. 3). If you can, provide greater
clearances from floor, ceiling and joining wall.
12" Min.
Minimum Clearance to Combustibles
Top
48 in.
12" Min.
2"
Bottom
0 in.
12
Front
36 in.
Vent-Free Gas Stove User's Manual
Rear
2 in.