If you attempt to use Performance Boost on more than one
surface cooking area in the same zone, "P" will briefly flash in the
display and the first surface cooking area selected for
Performance Boost will automatically be set back to the highest
power available setting. The last surface cooking area selected
will be set to Performance Boost.
1. Check that a surface cooking area has been selected.
2. Touch BOOST. "P" will appear in the display.
3. After 10 minutes, "P" will no longer be visible in the display
and the Performance boost function will no longer be active.
The surface cooking area turns back to heat setting level 9.
NOTE: The Performance boost function may automatically
deactivate to keep the internal electronic components of the
cooktop from becoming too hot.
Use the cooking timer to set times up to 90 minutes. The timer is
independent of any other control settings.
1. Touch the TIMER keypad. "01" appears in the timer display.
2. Touch the TIMER ">" (increase) key to increase the time in
Touch the TIMER "<" (decrease) key to decrease the time in
3. The timer will start to count down after a few seconds.
To change the time, touch the TIMER ">" (increase) or TIMER
"<" (decrease) keypad.
4. When the countdown is finished,"00" flashes and a tone will
NOTE: When the power is restored after an outage, the timer will
no longer be running.
Tones are audible signals, indicating the following:
Valid pad press
Slider is moved to "0" power level
Slider is moved to "Boost" power level
Invalid pad press
End of Timer cycle
Cleaning off the induction cooktop before and after each use will
help keep it free from stains and provide the most even heating.
For more information, see "General Cleaning" section.
Avoid storing jars or cans above the cooktop. Dropping a
heavy or hard object onto the cooktop could crack the
To avoid damage to the cooktop, do not leave a hot lid on the
cooktop. As the cooktop cools, air can become trapped
between the lid and the cooktop, and the ceramic glass could
break when the lid is removed.
For foods containing sugar in any form, clean up all spills and
soils as soon as possible. Allow the cooktop to cool down
slightly. Then, while wearing oven mitts, remove the spills
while the surface is still warm. If sugary spills are allowed to
cool down, they can adhere to the cooktop and can cause
pitting and permanent marks.
To avoid scratches, do not slide cookware or bakeware
across the cooktop.
To avoid damage to the cooktop, do not allow objects that
could melt, such as plastic or aluminum foil, to touch any part
of the entire cooktop.
To avoid damage to the cooktop, do not use the cooktop as a
Use cookware about the same size as the surface cooking
area. Cookware should not extend more than ½" (1.3 cm)
outside the area.
A. Surface cooking area
C. ½" (1.3 cm) Maximum overhang
Use flat-bottomed cookware for best heat conduction and
energy efficiency. Cookware with rounded, warped, ribbed or
dented bottoms could cause uneven heating and poor
Determine flatness by placing the straight edge of a ruler
across the bottom of the cookware. While you rotate the ruler,
no space or light should be visible between it and the
Make sure the bottoms of pots and pans are clean and dry
before using them. Residue and water can leave deposits