Advertisement
Available languages
Available languages
Assembly instructions
For product codes: 131 3736, 131 3749, 131 3752,
131 3765, 131 3778, 131 3781, 131 3794, 131 5602 & 131 5615
Assemble the 'Style E' bench as follows. First, attach the brackets ① to the wall, no more than 1,500 mm apart
from one another. For a seat height of 450 mm, which complies with DIN 7917, the lower hole of the wall bracket
spacer ④ between the wall and the bracket.
should be set at 297 mm above the floor, and the second hole should be 275 mm above the lower hole. Insert a
Next, screw the seat slats ② to the wall brackets from below using the round-headed screws ⑤. The seat slat
Finally, use the countersunk screws ⑥ and flange nuts to attach the backrest ③ to the upper hole.
nearest the front should protrude about 6 mm beyond the end of the wall bracket to create a seat depth of 400 mm.
Hook rail with spacers (product codes 131 5602 and 131 5615)
Start by checking that all parts are present. The quantities will depend on the number of rails and spacers ordered:
Spacers
①
M10×80 hex-head screws (DIN 933)
②
M10.5 form A washers (DIN 125)
③
M14×70 nylon wall plugs
④
M8×45 coach bolts (DIN 603)
⑤
M8 form A washers (DIN 125)
⑥
M8 hexagon nuts (DIN 934)
⑦
Hook rail
⑧
The spacers are used for mounting the hook rail.
For safety reasons, the hooks on the rail face the wall. Hook rails measuring 1.75 m or longer require at least three
spacers, while a rail of 3.20 m or longer will need at least four spacers. The ends of the rail should protrude approx.
10 cm past the relevant spacer.
Figure 9:
Borehole dimensions
Figure 8: Hook rail with spacers
Product code 131 5615
Product code 131 5602
Figure 10: Assembling
the spacer on the wall
Figure 11: Side view
of mounted hook rail
Version 10/2021 | Page 6
Advertisement
