KitchenAid Architect Series II KUDK03CTSS User Manual page 8

®
SURE-HOLD Cup and Stemware Holder
Fold down the extra shelf on the left-hand or right-hand side of the
mid level rack to hold additional cups, stemware or long items such
as utensils and spatulas.
NOTE: Remove the culinary tool basket(s) when washing tall
stemware or other tall items in the mid level rack.
FLEXI-FOLD DOWN™ Flexible Tines
The row of tines on the left-hand and
right-hand sides of the mid-level rack
can be adjusted to make room for a
variety of dishes.
To adjust the fold-down tines:
1. Grasp the tip of the tine that is in
the tine holder.
2. Gently push the tine out of the
holder.
3. Lay the tines down, toward the
center of the rack.
SURE-HOLD ® Light Item Clips
The light item clips hold lightweight plastic items
such as cups, lids, or bowls in place during
washing.
To move a clip:
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.
Removable Mid Level Rack Inserts
Your dishwasher has two removable mid level rack inserts which
allow you to adjust the rack to the type of load you are washing.
A
A. Removable rack inserts
B. Insert holding clips
8
To install rack inserts:
Place the insert end legs under the front or back rack wire as
shown below. Push down on the center insert wire until it slides
into the holding clip on either side of the center in the bottom of the
rack.
A. Lift removable insert wire to remove from holding clips
B. Holding clips
To remove inserts:
Lift up on the insert wire located toward the center of the rack to
release the insert from the holding clips. Lift insert out of rack.
Removable Mid Level and Culinary Tool Racks
The removable racks allow you to
wash larger items such as stock
pots, roasters, and cookie sheets
in the lower level rack.
IMPORTANT: Remove dishes
prior to removing the mid level
rack from dishwasher.
To remove the rack:
1. To access track stops, pull
the rack forward until it stops
and clicks into place.
2. To open track stops, flip the track stop to the outside of the
track.
3. After opening both track stops, slide front wheels up and out
of the slot in track. Continue to pull rack forward in track and
slide the back wheels up and out of the track.
4. Close track stops.
5. Slide rack tracks back into dishwasher.
To replace the rack:
1. Gently pull rack tracks forward in dishwasher until they stop
and click into place.
2. To open track stops, flip the track stop to the outside of the
track.
3. Place the back rack rollers on each side of the rack into the
track slot and roll the rack back into the tracks.
4. Insert front rack rollers on each side of the rack into the rack
slots.
5. Close track stops on both sides of rack and slide rack back
B
into dishwasher.
A
B
A
B
A. Track stop
B. Track