Operation - The Andersons SSD Assembly Instructions Manual

Assembly and Operation Instructions

Operation

Before filling Hopper, make sure spreader
Step 1:
Handle Lever is in the "OFF" position. Always fill
spreader on walk or drive, not on the lawn.
Loosen Rate Control Knobs and move the Tie
Step 2:
Bar to setting recommended for the product applied. If
setting is not known, refer to "DETERMINING
APPLICATION RATES" section of this book. Retighten
knobs after setting is made.
Always push spreader, do not pull. Start
Step 3:
spreader in motion and as it passes over the area to be
treated, push Handle Lever to the "ON" position. Close
Handle Lever at the end of each pass.
Operate spreader at 3 MPH pace. (33.3 feet in
Step 4:
7.5 seconds)
Apply two header strips at each end of area to
Step 5:
treated and then proceed lengthwise between the
header strips. Be sure to overlap the wheel tracks slightly
to prevent streaking.
When applying lime, do not use limestone
Step 6:
that is so finely ground that it will pack inside the
Hopper, or use hard, abrasive particles which will
damage the spreader. Use only compacted, free flowing,
non-abrasive lime products.
TheAndersons_PSSD-AN_ Manual_0720-2 PAGE 4