Pressure Relief Option; Pressure Relief Valve Setting; Portable Base Storage - Task Force Tips CROSSFIRE Manual

With stow-a-way 800 base

Table of Contents

5.9 PRESSURE RELIEF OPTION

The optional pressure relief valve on the single inlet portable base can be adjusted to open between 90 and 300 psi. The pressure

relief valve, TFT part A1820, is set at the factory to open at 150 psi. To change the relief pressure refer to the label on the bottom side

of the pressure relief valve. A pressure relief valve can be added to the single inlet portable base by removing the cover on the side

of the base. For additional information call 800-348-2686.

To set the relief valve pressure turn the adjusting screw on the relief valve housing until the surface of the screw is even with the

desired pressure. Do not cap or plug discharge opening.

The portable base may be stored in a compartment, on the optional storage bracket, TFT part number XF-B. This bracket is NOT

designed to withstand the reaction forces of an operating monitor stream. It is to be used for storage and transportation only. The

storage bracket may be mounted on a horizontal surface, horizontally or vertically on a vertical surface, or on the underside of a

horizontal surface such as the top of a compartment. A strap helps hold the base on the bracket. Mounting instructions are supplied

with the bracket.

©Copyright Task Force Tips LLC 1999-2018

XF-B

STORAGE

BRACKET

Adjusting

Screw

Relief Valve

Discharge

Opening

LIX-040 May 30, 2018 Rev10

Table of Contents

Do you have a question about the CROSSFIRE and is the answer not in the manual?