Haier HDW15F3S1 User Manual page 9

NZ AU
CAUTION!
Ensure always that all connections (power supply, drain and fresh
water hose) are firm, dry and leak free!
Take care these parts are never to be crushed, kinked, or twisted
If the supply cord is damaged, it must be replaced by the service
agent (see warranty card) in order to avoid a hazard.
Drain hose to waste water
connection
The internal diameter of the stand pipe
with vent-hole must be minimum 40 mm.
Put the drain hose for approx.80 mm
in the wastewater pipe.
Attach the U-support and secure it
sufficiently
Drain hose to sink connection
When connecting the drain hose to a
sink trap with a drain hose spigot, make
sure that the drain hose is supported
to the height of the bench.
Ensure the drain spigot has a minimum
hole diameter of 15 mm and it has been
drilled out.
Power connection
As shown in the figure, the power supply
is plugged into an externally accessible
place through the service hole for easy
plugging.
Installation
8