Zodiac ARCO ARCOMAX Instructions For Installation And Use Manual page 3

may cause an electric shock. Contact a qualified technician.
• Do not place anything on the robot or on the control box (except for the radio
control).
• Do not use the robot if any of its components are defective or missing (pump,
turbine, screw, nut, cable, etc.).
• Do not shorten or extend the floating cable.
WARNINGS RELATED TO ELECTRICAL APPLIANCES
• The power supply to the appliance must be protected by a 30 mA Residual Current
Device (RCD), in accordance with standards in force in the country of installation.
This circuit breaker must be tested before using the robot. Press test button : the
circuit breaker must stop the current ; press button again : it restarts the current. If
the operation is not carried out according to these instructions, the circuit breaker
is defective. If the circuit breaker shuts off the power outside the test procedure, it
indicates that there is a current leakage which can cause an electric shock. In this
situation, do not use the robot and contact the After Sales Service for assistance.
• The pump must be supplied by a residual current device with a nominal residual
operating current ≤30mA.
• This Class III electrical device (the robot) is supplied with an independent power
supply cabinet. The robot alone can only be used with the supplied control box.
• Do not use an extension cord to connect the appliance ; connect appliance to
appropriate socket.
• When the mains plug is connected to the electrical installation, Under no
circumstances should you lift, transport or turn over the robot.
• Before carrying out any operations, check that :
- The voltage indicated on the appliance information plate corresponds to the mains
voltage.
- The power grid is adapted to the power requierments of the appliance, and is
grounded.
- The plug (where applicable) is suitable for the socket.
• In the event of abnormal operation, or if the appliance emits an odour, stop it
immediately, disconnect the power supply and contact a professional.
• Before carrying out any maintenance or servicing on the appliance, ensure that it is
switched off, that it is completely disconnected from the power supply and that any
other equipment or accessories connected to the appliance are also disconnected
from the power supply.
• Do not disconnect and reconnect the appliance to the power supply during the
operation.
• Do not pull on the power cable to disconnect it from the power supply.
• If the power cable is damaged, it should only be changed by the manufacturer, an
authorised representative or a repair shop.
• Do not service or maintain the unit with wet hands or if the unit is wet.
• Before connecting the device to the power source, check that the terminal block
or power outlet to which the device will be connected is in good condition and not
damaged or rusted.
• Do not drop the floating cable plug into water, it is not waterproof. Do not drop it on
the ground as this could damage it.
• In stormy weather, unplug the appliance to prevent it from suffering lightning
damage.
EN
2