Workpiece
Setup
Content
Unit Description
This unit describes how to set the workpiece offset and test the tool re-
sults.
Unit Content
Manual
start
spindle
Create
workpiece
offset
Test tool
offset
results
End
808D
SEQUENCE
Manual
start
spindle
Before measuring, the spindle can be started as follows:
Press the "Machine" key on the PPU.
Press the "JOG" key on the MCP.
Press the "T.S.M" SK on the PPU.
Enter "500" in "Spindle speed" on the PPU.
Select "M3" as the "Spindle direc-
tion" using the "Select" key on the
PPU.
Press "CYCLE START" on the MCP.
Page 23
s
A tool must have been loaded into
the spindle.
Operating and Programming — Milling