Table of Contents
Advertisement
NEX 6620A User's Guide
Hard Disk(s) fail (08)
Sector Verify failed.
Invalid EISA Configuration
PLEASE RUN EISA CONFIGURATION UTILITY
The non-volatile memory containing EISA configuration information was programmed incorrectly or has
become corrupt. Re-run EISA configuration utility to correctly program the memory.
NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the
EISA Configuration Utility.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys are being
pressed during the boot.
If you are purposely configurating the system without a keyboard, set the error halt condition in Setup to
HALT ON ALL, BUT KEYBOARD.
continue the boot.
Keyboard is locked out-Unlock the key
BIOS detect the keyboard is locked. P17 of keyboard controller is pulled low.
Manufacturing POST loop
System will repeat POST procedure infinitely while the P15 of keyboard controller is pull low. This is
also used for M/B burn in test.
Memory Address Error at ...
Indicates a memory address error at a specific location. You can use this location along with the
memory map for your system to find and replace the bad memory chips.
Memory test fail
BIOS reports the memory test fail if the onboard memory is tested error.
Memory parity Error at ...
Indicates a memory parity error at a specific location. You can use this location along with the memory
map for your system to find and replace the bad memory chips.
MEMORY SIZE HAS CHANGED SINCE LAST BOOT
Memory has been added or removed since the last boot. In EISA mode use Configuration Utility to
reconfigure the memory configuration. In ISA mode enter Setup and enter the new memory size in
the memory fields.
Memory Verify Error at ...
Indicates an error verifying a value already written to memory.
system's memory map to locate the bad chip.
OFFENDING ADDRESS NOT FOUND
This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY ERROR
messages when the segment that has caused the problem cannot be isolated.
BIOS Setup
This will cause the BIOS to ignore the missing keyboard and
Rev. B0
Use the location along with your
0301
4-31
Advertisement
Table of Contents
