5.7.4
WSU: CAN bus connector
The WSB can communicate status and be controlled by CAN bus, allowing connection to BMS or smart
Molex MX150 series. Part number 33471-0201,
mating connector part number 33481-0201:
Pin 1
5.7.5
WSU: External control connector
Molex MX150 series. Part number 33471-3301,
mating connector part number 33481-0301:
5.7.5.1
Sleep
When the WSU is not in use, Sleep mode can be used to reduce the current the WSU draws from the
battery. See 6.3 for details.
left
unconnected.
5.7.5.2
Enable
the signal it to initiate the charge process once the vehicle has determined that it is correctly docked
If the WSU is operating in CAN mode, the EXT_Enable signal pin can left unconnected.
Pin 1
The use of Sleep mode is optional, and if not required this pin can be
Pin
Assignment
1
CAN_HIGH
2
CAN_LOW
Pin
Assignment
1
EXT_Enable
2
Sleep
3
EXT_Signal_GND
The purpose of
23