Residual Hazards; Returning Products - Spirax Sarco HM Series Installation And Maintenance Instructions Manual

1.13 Residual hazards

In normal use the external surface of the product may be very hot. If used at the maximum permitted
operating conditions the surface temperature of some products
may reach temperatures in excess of 425 °C (797 °F).
Many products are not self-draining. Take due care when dismantling or removing the product from
an installation (refer to 'Maintenance instructions').
1.14 Freezing
Provision must be made to protect products which are not self-draining against frost damage in
environments where they may be exposed to temperatures below freezing point.
1.15 Disposal
Unless otherwise stated in the Installation and Maintenance Instructions, this product is recyclable
and no ecological hazard is anticipated with its disposal providing due care is taken.

1.16 Returning products

Customers and stockists are reminded that under EC Health, Safety and Environment Law, when
returning products to Spirax Sarco they must provide information on any hazards and the
precautions to be taken due to contamination residues or mechanical damage which may present
a health, safety or environmental risk. This information must be provided in writing including Health
and Safety data sheets relating to any substances identified as hazardous or potentially hazardous.
1.17 Working safely with cast iron products on steam
Cast iron products are commonly found on steam and condensate
systems. If installed correctly using good steam engineering
practices, it is perfectly safe.
However, because of its mechanical properties, it is less forgiving
compared to other materials such as SG iron or carbon steel.
The following are the good engineering practices required to
prevent waterhammer and ensure safe working conditions on
a steam system.
Safe Handling
Cast Iron is a brittle material. If the product is dropped during
installation and there is any risk of damage the product should
not be used unless it is fully inspected and pressure tested by the
manufacturer.
HM and HM34 Inverted Bucket Steam Traps
5
IM-S03-11 CMGT Issue 5