Kohler 15RYG Installation Manual page 37

Controller Configuration Mode:
Hold the Select button:
Now release the Select button.
Press:
or
or
or
Now either save your settings or enter the Advanced Configuration Mode to
set the engine data inputs, battery voltage, and communications.
Press:
or
or
Note: Shaded boxes show which number in the controller display changes when the up or down arrow
key is pressed.
Figure 5-2 Configuration Mode (system voltage/frequency, unit configuration, and engine type parameters)
TP-6329 8/07
Move the generator set master switch to the RUN
position. (The generator set engine will not start.)
Wait about 5 seconds until the display shows the
program version number. (The number may be
different than the one shown here.)
Press the down arrow key and then the up arrow
key 3 times to enter the configuration mode.
(This is the controller "password.")
To set the voltage/frequency setting. See
Figure 5-1.
To step to the next parameter, unit configuration
Uc.
To set the unit configuration setting to Uc01, if
necessary.
To step to the next parameter, engine type Ec.
To set the engine type to Ec03 OR Ec06, if
necessary. See Figure 5-1.
To step to the next parameter, advanced
configuration mode or save mode selection.
To enter advanced configuration mode.
Go to Figure 5-3.
To proceed to the save mode without
entering the advanced configuration mode.
Go to Figure 5-4.
Display:
. 0
1 0 4
U u 0 1
U u X X
U c 0 1
E c 0 X
A d n c
E d 0 0
S A V E
Section 5 Controller 37