Fisher & Paykel DISHDRAWER DD60DI9 User Manual page 42

'A' fault codes
Follow the steps below to try and fix the issue.
DISPLAY
+ all modifiers
RINSE
, + all modifiers
DELICATE RINSE
, + all modifiers
FAST DELICATE
, +
FAST DELICATE
+ all modifiers
Current wash program +
SANITIZE
42
POSSIBLE CAUSE
A1:
Supply fault.
A3:
drain. The drainage
hose may be
blocked or kinked,
or the connection
to drainage pipe
may be blocked.
A6:
arm has loosened
or come off its
mounting, or
water pressure
is too low, or a
combination of low
water pressure and
excessive foaming.
A7:
program –
DishDrawer™
Dishwasher has
RINSE
detected excess
foam in the drawer.
A09:
cycle hasn't met
temperature
needed to
sanitize dishes.
FAULT CODES
Water
Drawer cannot
The spray
Auto recovery
Sanitize
WHAT TO DO
1 Ensure the water supply is
turned on.
2 Press once to stop the beeping,
then again to clear the fault.
3 Press to resume the
wash program.
1 Ensure the drainage hose
and connection to pipes are
not blocked.
2 Press once to stop the beeping,
then again to clear the fault.
3 Press to resume the
wash program.
1 Open the drawer and check the
spray arm.
2 If the spray arm has loosened
or come off its mounting,
re-fit it. Check that it is firmly
seated and turns freely.
Refer to 'Maintenance'.
3 Press once to stop the beeping,
then again to clear the fault.
4 Press to resume the
wash program.
1 Let the auto recovery program
run until it is complete. The
wash program will resume when
the auto recovery program
has completed.
2 Check that you are using the right
detergent before running another
wash program.
3 If the drawer is still filled with
foam at the end of the wash
program, contact Customer Care.
1 Check if the water supply has
been turned off or the wash
program interrupted.
2 Press once to stop the beeping,
then again to clear the fault.
3 Run the sanitize cycle again.