Fisher & Paykel SINGLE DISHDRAWER DD60SHI9 Installation Manual page 14

1
2
3
4
14
FIT THE CUSTOM PANEL
Remove both side pins.
Carefully pull the bracket down and
out from DishDrawer™ Dishwasher and
unplug the Knock-to-Pause module and
earth wire.
Remove the Knock-to-Pause module
from the back of the bracket.
On the back of the panel, mark the
centre and align the base of the bracket
with the base of the panel.
Secure the bracket to the panel using a
minimum of 3 screws on either side.
5
6
7
8
Attach the Knock-to-Pause module to
the panel as shown.
Ensure the Knock-to-Pause module is
oriented correctly and is not in contact
with the bracket before securing.
Electric shock hazard:
To earth the panel bracket, connect the
earth wire from the product to one of
the tabs. Any custom metal components
(e.g. handle) that extend past the
rubber seal must be earthed also.
Reconnect the Knock-to-Pause module
to the UI 1 slot on the wash controller as
shown. Reconnect the earth wire to the
panel bracket before fitting the panel to
the product.
Re-insert both side pins to each drawer.
Insert a Phillips screwdriver into the
hole above the side pin and rotate to
adjust the panel alignment. There is a
maximum travel distance of ± 2mm.
Repeat on the other side if required.
Ensure the minimum clearance gap of
2mm is maintained and that the door
panel does not rest on the surrounding
cabinetry when closed.