Lagrange Crepiere Pro Manual page 39

FIRST USE AND DAILY OPERATION
FIRST USE
When unpacking the appliance, take care to remove and
*
check all packing for parts as well as packets and additional
packing information.
Make sure that no parts or accessories are missing or defective.
*
Before using the appliance, clean the cooking surface thoroughly
*
with soapy water to remove any impurities from the packaging.
Dry thoroughly.
A new appliance may smoke and/or give off an odour when used
*
for the first time. To reduce the chance of smoking or odour, it is
recommended to allow the appliance to heat for
then cool for approximately 30
START-UP AND OPERATION
Place the appliance on a firm, flat and heat-resistant surface.
*
For each use, switch on the appliance and let it preheat for
*
at °C.
200
The green light switches on when the appliance is powered up,
*
i.e. when the temperature adjustment button is no longer on the
" 0 " position. The red light switches on as the appliance heats
up. The green light switches back on when the set temperature
is reached.
Set the thermostat to the right temperature according to the
*
crepe, pancake or other recipe you want to cook, and according
to your cooking preferences.
minutes and
10
minutes before the first use.
min
10
Once the temperature is reached (green light on), use a brush or a
*
paper towel to grease the surface of the plate with sunflower oil.
Pour a ladleful of pancake batter in the centre of the plate and
*
spread it with the spreader.
Tip: dip the spreader in a water container and wipe it before each
*
spreading to remove any batter residue.
Wait for a few seconds and use the spatula to lift up a side of the
*
pancake and turn the spatula over to lift up the rest of the pancake.
Flip the pancake over and let it cook a few seconds.
*
Tip for buckwheat crepes: garnish the crepe directly on the plate
*
without flipping it over.
BELOW ARE A FEW THERMOSTAT ADJUSTMENT
RECOMMENDATIONS:
Wheat crepes between
*
Buckwheat crepes between
*
Tortillas and naans
200
*
Pancakes and blinis between
*
AFTER USE
To turn off the appliance, turn the thermostat down to the
*
lowest setting.
Allow the appliance to cool and then unplug the cord.
*
You may then wrap the cord around the cord winder on the rear
*
of the appliance for ease of storage.
39
E N G
and °C
200 220
210 and 230 °C
°C
200 and 220 °C