Specifications And Requirements; Rough-In Drawings; Capacities And Measurements - Fetco LEGACY HWB-5 Series Users Manual And Operator Instructions

Specifications and Requirements

Water Requirements:
HWB-2000 20-75 psig, (138-517kPa) 0.75gpm/(2.8 lpm)
Water supplied to hot beverage equipment should be filtered
Water supplied Hardness >100 TDS (5.5 grain)
Water inlet fitting: 3/8 inch male flare.
Dispense Volume: Software controls flowrate so that water dispensed is at programmed temperature.
.

Rough-In Drawings

HWB-10
HWB-5
Front
Front
HWB-25
Front
NOTES
-Model designation indicates minimum flow rate per hour, e.g. HWB-5 is five gallons per hour
-All utility connections are from back of equipment. All electrical and water utility connections per local codes.
-Tank service drain (at bottom) must not be plumbed. It is for service or to drain tank to relocate equipment
-Tank vent must never be obstructed. It is for normalization of hot water tank pressure to fill and dispense water. The
hot water tank is not pressurized - it is an atmospheric hot water dispense system. If a condensate drain is desired: use
heavy wall or ridgid tubing with a minimum ⅜ inch ID. Do not plumb to drain-leave a minimum 12" air gap to drain.

Capacities and Measurements

Model Height Width
30 in 10 in
HWB-5
762 mm 254 mm
30 in 16 in
HWB-10
762 mm 406 mm
30 in 21 in
HWB-15
762 mm 533
30 in 28 in
HWB-25
762 mm 711 mm
Go to fetco.com for the latest versions of all information
HWB-5 & HWB-10
Side
HWB-25
Side
Water tank
Depth
capacity
23⅝ in 6.0 gal
599 mm 22.7 liter
23⅝ in 12 gal
599 mm 45.3 liter
28 in 20.7 gal
711 mm 78.2 liter
28 in 30.5 gal
711 mm 115.5 liter
Temperature, as set by factory:
200°F (93°C) inside water tank (at sea level)
Electrical: See electrical configuration chart.
HWB-15
Front
On-Off
Electrical Water
Switch
Inlet Inlet
Tank
Ready
Vent
Lamp
Main
Faucet
shut-off
Hot
water
Tank
service faucet
drain
All models-back
Utility connections
Empty Filled Shipping
Weight Weight Weight
58 lb 108 lb 65 lb
26.3 kg 49.0 kg 29.5 kg
64 lb 163 lb 72 lb
29.0 kg 74.0 kg 32.7 kg
70 lb 243 lb 105 lb
31.7 kg 110 kg 47.6 kg
119 375 lb 160 lb
53.9 kg 170 kg 72.5 kg
Page 2
HWB-15
Side
IP44 Maritime equipment
are factory equipped with
flanged feet.
These feet have 11/32"
holes for fasteners to
attaching the brewer to
the counter
Flanged feet-IP44
All models-front
maritime models
User features
Shipping Dimensions
32X12X27 inch
813X355X686 mm
32X21X25 inch
813X533X635 mm
33X24X28 inch
840X610X710 mm
33X37X32 inch
840X940X810 mm
P112 Revised November 2021