Module
Handling
9. After approx. 5 s switch on
•fDIP-1 = OFF
•fDIP-2 = ON
10. For approx. 1 s press and hold the
11. At the start of the bright light
12. Repeat steps 6 to 11
13. You can also teach in multiple light channels on
•fe.g. red and green = yellow
•fe.g. red and green and blue = white
14. On completion of the teach-in
•fDIP-1 = ON
•fDIP-2 = ON
36
control S1:
P-key on the back.
of the LED briefly press the UP key on
the hand-held transmitter.
for the other 3
light channels.
one channel of the hand-held transmitter.
To do this in step 7
switch on two colours.
To do this in step 7
switch on three colours.
switch S1:
Result
The teach-in mode is now activated for 5 min.
•fStatus LED light 1x orange
•fThe connected and activated
LEDs are bright and dark alternately.
•fThe LEDs go off.
•fThe teach-in for this channel is complete.
The teach-in mode is set.