5
Teach-in of the limit positions of the actuators
Module
Handling
1. Adjustment of speed:
•frotate right = faster
•frotate left = slower
Optimum value: maximum speed
2. Adjustment of cut-out force:
•fstep 0 = low force
•fstep 9 = high force
Only select a step as high as necessary!
3. Switch the power
supply to ON.
4. Close the pergola completely.
5. Run 3 complete paths
all to the limit position.
6. Check intermediate position 1:
Press the DOWN key briefly twice
in succession.
24
NOTE
If the green LED is still flashing after
three movements, run another one.
Result
SPEED
FORCE
•fLED-1 flashes green on the control unit.
•fLED-1 lights green on the control unit.
•fLED-2 does not light red on the control unit.
•fPergola stops at INT-1 (default 33% open).