Table of Contents
Advertisement
To clear the administrator password, follow the same steps as in changing an
administrator password, but press <Enter> when prompted to create/confirm the
password.
User Password
If you have set a user password, you must enter the user password for accessing
the system. The User Password item on top of the screen shows the default Not
Installed. After you set a password, this item shows Installed.
To set a user password:
Select the User Password item and press <Enter>.
1.
2.
From the Create New Password box, key in a password, then press <Enter>.
3.
Confirm the password when prompted.
To change a user password:
Select the User Password item and press <Enter>.
1.
2.
From the Enter Current Password box, key in the current password, then press
<Enter>.
From the Create New Password box, key in a new password, then press <Enter>.
3.
4.
Confirm the password when prompted.
To clear a user password:
Select the Clear User Password item and press <Enter>.
1.
Select Yes from the Warning message window then press <Enter>.
2.
Secure Boot
Secure Boot
Secure Boot can be enabled if the system is running in User mode with
enrolled platform Key (EPK) or if the CSM function is disabled. Configuration
options: [Disabled] [Enabled]
Secure Boot Mode
In Custom mode, Secure Boot policy variables can be configured by a
physically present user without full authentication. Configuration options:
[Standard] [Custom]
Key Management
The Key Management item allows you to modify Secure Boot variables and
set Key Management page.
Platform Key (PK)
Configuration options: [Update]
Key Exchange Keys / Authorized Signatures / Forbidden Signatures
Configuration options: [Update] [Append]
Chapter 3: BIOS setup
3-13
Advertisement
Table of Contents
