Table of Contents
Advertisement
Reinstalling the Gripper Restraint
If the library is to be moved to a different location, use this procedure to re-install the
gripper restraint:
NOTE: To relocate the library or prepare it for shipment, see Chapter 5, "Relocation."
1. Pull the gripper all the way out toward you (see Figure 4-23).
2. Insert the gripper restraint 1 into the follower guide so that it is in the same
position as shown in Figure 4-23.
3. Slide the gripper and restraint to lock them into the groove (approximately half
way in).
4. Rotate the gripper 90 degrees.
5. Line up the restraint and then attach it. See the section "Removing the Shipping
Restraints" for attaching information.
Figure 4–23: Reinstalling the gripper restraint
ESL9000 Series Tape Library Unpacking and Relocating Guide
1
SHR-1919
Unpacking and Moving the Library
4–27
Advertisement
Table of Contents
