3.3. Park the vehicle in an open area away from trees, power lines, and tall buildings. Remove loose articles, cell
phones, and electrical accessories near the GPS antenna. Press the VOL/Power AUDIO knob to turn on the
audio-navigation unit. When the Enter code screen appears, press and hold the knob for about 2 seconds. This
lets the PCM check that the vehicle's VIN matches the one saved in the unit. You will hear a long beep when the
unit exits the anti-theft mode. Release the knob.
NOTES
•
If the audio-navigation unit does not exit the anti-theft mode, enter the anti-theft code using the audio touch
screen display.
•
If you need the anti-theft code, you can get it from the iN using the audio-navigation unit serial number. You
can easily get that number without removing the audio-navigation unit. To get the serial number and the code,
do this:
–
Press and hold the INFO, SETTINGS, and BACK buttons at the same time.
–
At the Select Diagnosis Items screen, select Detail Information & Settings, Unit Check, then ECU
Info. The system runs a short diagnostic, then the audio-navigation unit serial number appears at the
bottom of the screen.
–
Go to Anti-theft Code Inquiry on the iN, and look up the five-digit anti-theft code.
–
If the code does not work, call the American Honda warranty department at 310-783-3240. Do not call
Tech Line.
Page 4 of 9