Advertisement
NOTES
•
When the voice tutorial is turned on, you need to press and release the Talk button twice to give a command.
•
If the system does not understand your commands, see the Improving Voice Recognition section in the online
navigation manual.
3.
NAVIGATION SYSTEM SETUP AT THE TQI
The navigation system is basically ready to use when the vehicle is delivered to the dealership. The system has features
to reduce the potential for driver distraction. Some touch screen menus are limited or unavailable (grayed out) while
driving to encourage the use of voice commands for the navigation and audio systems.
Since the navigation system interfaces with other vehicle systems, it is important that all of the systems are initialized. To
initialize the navigation system, follow these steps:
3.1. Do the regular TQI of the vehicle.
3.2. Turn the power system to ON.
NOTE
You may see the factory In Line Diag screen below, which means the audio-navigation unit is in the factory
diagnostic mode. If you do, follow these steps to exit the mode; otherwise, skip them, and go to step 3.3.
•
Select Start Diag.
•
Press and release all of the buttons on the steering wheel that are shown in the In Line Diag screen. The
icons should turn green.
•
Press and release the Talk button. Make a loud sound (like snapping your fingers or clapping your hands) or
say "testing" in a normal voice towards the microphone in the ceiling console. The mic level indicator should
reach at least six bars.
•
When you have completed all of the tests, the icons will be green. If any of them are red, troubleshoot the
applicable system. Refer to the service information. Select Exit Diag to exit the mode.
•
Turn the power system to OFF, then to ON, to make sure the In Line Diag screen does not reappear.
Page 3 of 9
Advertisement
